FocusCanada Forums

Full Version: Fuses
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
How do i pull these fuses?

Ive tryed pulling by hand... No Go, I pulled the cap off. Is thier a way that i dont know?

Im trying to do the Fog light mod.

01-yellow-ZX3

Use the little yellow fuse puller, it should be attached to the door on the fuse comparment in the engine bay.

If not, try needle nose, but lightly.
The foglight mod uses the relays, not fuses. The relays are pretty tough to get out, since the prongs face both ways so you cant really wiggle them out.
Ya I broke the cap off 12 lol, Not sure what to do now.
The cap may "snap" back on, mine did after it snapped off when I tried pulling with vice grips.

It might be easier with a warm engine as the female connector may expand more than the male? When I did finally do it, it was right after a highway run.

I had the same problem but eventually got it off with lots of simultaneous pulling, wiggling and cursing.
2001 ZTS,Oct 4 2004, 01:18 AM Wrote:It might be easier with a warm engine as the female connector may expand more than the male? When I did finally do it, it was right after a highway run.
Warning: Female insert may expand during heated stress :P


thats for u perverst out there :rolleyes: