FocusCanada Forums

... install these fricken H7 bulbs in my MACH headlight assemblies.

H7 bulb connector


This is what the mounting point looks like (shouldn't there be a wire clip attached to one of these screws?)


This is bulb connector with metal clip attached



And this is the metal clip removed from the bulb connector.

Are those for the high beams? Because i know low beams are d2s

(06-15-2011, 11:08 AM)GFXjamie Wrote: [ -> ]Are those for the high beams? Because i know low beams are d2s

Yeah no problem with the low beams (and yes D2S) ... H7s are indeed high beams and buried to one side in the housing - my hand doesn't even fit down there.

Do you have the Ford Racing Hids? Or the Svt Hids? I know there shouldn't be a diiference, but they could have changed the bulb holder to accommodate the DRL function maybe? I know mine has a wire clip with a plastic bulb socket that are a huge pain to try and change

(06-15-2011, 09:52 PM)SL8RZZX3 Wrote: [ -> ]Do you have the Ford Racing Hids? Or the Svt Hids? I know there shouldn't be a diiference, but they could have changed the bulb holder to accommodate the DRL function maybe? I know mine has a wire clip with a plastic bulb socket that are a huge pain to try and change

Even worse - they are the Depo knock-offs ... any idea Gord where I could get me some of those wire clips

Why not grab just some wire and wrap it around the clip to each screw, then use a small ratchet with and extension and a screw driver bit to tighten?