FocusCanada Forums

Yeah, all by myself...finally got the sucka up and bolted in...

Here is my custom made shifter busging installed...



So basically, what I did was plop the Getrag into a milk crate, with the car up in the air, and slid it into position...



I carefully jacked the car down to get a better alignment...



And wiggled and tilted and lifted it up into place...started a few bolts top and bottom to draw it in...



And that's it!!
Wasn't too difficult, but I worry that maybe with my wiggling and tilting, that I might of caused damage to the main seal, or the throw out bearing...? Scary thought..
Time will tell!
That's as far as I got when I broke the bulb in my trouble light!! Dammit!

Oh, and the custome shifter bushing installed and cable mounted...



I'm a little concerned that the one I've sold will be seriously difficult to install with the tranny still in the car!!!

Which clutch is that, man? Looks nice! It's always a shame to have to cover them up.

And GJ on the install too!

southbend?

jesus christ thats a rusty oil pan.

^^^my thought exactly.
Looks like that car needs oil spray loving...a bit late though

Southbend Stage 1....
Rust!? Pfff...this is Focus CANADA right? lol

(09-10-2011, 10:26 AM)NikiterZTS Wrote: [ -> ]^^^my thought exactly.
Looks like that car needs oil spray loving...a bit late though

yeah, totally too late.

Oiling would of made it difficult to blast and epoxy prime the underside