Seriously Pissed Right Now - Printable Version +- FocusCanada Forums (//www.focuscanada.net/forum) +-- Forum: Canadian Focus Community (//www.focuscanada.net/forum/forumdisplay.php?fid=3) +--- Forum: Focus Talk (//www.focuscanada.net/forum/forumdisplay.php?fid=18) +--- Thread: Seriously Pissed Right Now (/showthread.php?tid=11529)

Seriously Pissed Right Now - NOS2Go4Me - 12-20-2005 damned damned damned HELL. I found it. Not impressed with their site. Apparently I ordered the wrong damned part. damn. damn damn damn Seriously Pissed Right Now - meford4u - 12-20-2005 ct should be able to help you. Seriously Pissed Right Now - SVT ZX3 - 12-20-2005 OWN3D by tha new UDP! Seriously Pissed Right Now - NOS2Go4Me - 12-20-2005 damn damn damn Seriously Pissed Right Now - S2 - 12-20-2005 Are you talking about that ZX2.com guy selling his own UDPs? That guy was over on FF being a total ass and had his account 'adjusted' on there. If not, what are you talking about? Curious....... Seriously Pissed Right Now - NOS2Go4Me - 12-20-2005 They had a typo on their site... and the belt I ordered for my Focus was massively too short. Even excluding the AC compressor... then it was a tad too long. HOLY FAWK :angry: On the phone right now trying to find the right belt and have it ordered in. I'm going to probably order the 64.5" belt CT recommended... as apparently the other part number listed doesn't exist! :angry: Seriously Pissed Right Now - 2001 ZTS - 12-20-2005 Seriously Pissed Right Now - schade - 12-20-2005 just tell them to get out some string and start measuring .. otherwise CT or ford should have a variety of lengths of belts in stock that you should find something that works Seriously Pissed Right Now - Flofocus - 12-21-2005 Should of done this mod yourself. :P Seriously Pissed Right Now - NOS2Go4Me - 12-21-2005 I still woulda ordered the wrong damn belt. D'oh! Getting the new belt after work, and then deciding whether or not it'll get done this week. Not sure. At least they've loosened it off some :P . Seeing as they were able to do the install without removing the wheel, technically I should be able to do the same. Hmm. It's also dropping in temperature this week for the remainder... not looking forward to that. Especially not if I am going to be attempting a pulley swap. I've done exhausts in -15C weather... ick.