[hyprlte]

hey, i know its a stupid question but i've never done it before. Is there a page i can read that will explain how to change the front bumper side markers? and if not how do i go about doing it? thanks

[oldeguy]

I haven't done it myself, but if you use the search feature on this site, type in clear corners, and something will show up, and check them out to see which is the best to use.

[ZX5focused]

focus hack instructions

Quote:How To Do It!
Time Required:
Less than 15 minutes per turn signal
Tools Needed:


Socket set or adjustable crescent wrench
Procedure:


1) You may want to jack the front end of the car up with a floor jack on proper jacking points. It isn't required though.
2) Look up under the bumper where the turn signal sits. You may want to use a mirror if you can't get under the front end.
3) Twist the bulb holder Anti-Clockwise and remove it from the lens.
4) Using the wrench or socket, un-do the 2 "cheapo" sheetmetal nuts which hold the turn signal housing to the bumper.
5) Pull the turn signal housing out from the bumper.
Assemble in reverse order.

[ANTHONYD]

Easiest install for the Fofo fo sure!

[hyprlte]

thanks very much!!

[FocusGuy7476]

15 mins for both sides

[ZX3_2NV]

very simple for sure just jack it up and make sure you use a jack stand for safty reasons