12-16-2005, 08:51 AM
Hey Mitch, I know I was talking about this before, but sort of put it on the back buner.
Can you source a 3" 90 degree bend with a 2.5" (or less) bend radius?
also 2 hump connectors and 4 hose clamps to hold it all together?
thanks.
I might take some measurements of the plastic intake elbow that connects to the compressor inlet. might be worth looking into replacing it with something a bit better quality.. replace it with a tight radius elbow tapped for the bypass. ..
no hurry, but want to start planning my post-christmas wish list..
thanks
Can you source a 3" 90 degree bend with a 2.5" (or less) bend radius?
also 2 hump connectors and 4 hose clamps to hold it all together?
thanks.
I might take some measurements of the plastic intake elbow that connects to the compressor inlet. might be worth looking into replacing it with something a bit better quality.. replace it with a tight radius elbow tapped for the bypass. ..
no hurry, but want to start planning my post-christmas wish list..
thanks
Contribute to focuscanada.net's future!
Donations of $20 and over get a custom title!