10-07-2007, 03:04 AM
ok i got it. I basically took the torx bit off the driver and put it in the screw first, then i put my screw into the torx bit.
It wouldn't fit through the hole together but separately i got it to work, phew!
Here's some pics so far. But i noticed that the color is a little off?
The can i used was Duplicolor Silver Frost (code: TS) and TS is the exact code on the side of my door label.
Why is the color a little off...it looks a bit darker...is it because i didn't clearcoat enough or maybe because it's not polished?
![[Image: 1005882dn5.th.jpg]](http://img205.imageshack.us/img205/8445/1005882dn5.th.jpg)
It wouldn't fit through the hole together but separately i got it to work, phew!
Here's some pics so far. But i noticed that the color is a little off?
The can i used was Duplicolor Silver Frost (code: TS) and TS is the exact code on the side of my door label.
Why is the color a little off...it looks a bit darker...is it because i didn't clearcoat enough or maybe because it's not polished?
![[Image: 1005882dn5.th.jpg]](http://img205.imageshack.us/img205/8445/1005882dn5.th.jpg)
![[Image: doorhandlesbq7.th.jpg]](http://img205.imageshack.us/img205/5013/doorhandlesbq7.th.jpg)
Be the change you want to see in this world.