[NoiSeeVT]

Heres the problem with 3 subs you divide it so each sub recieved 1/3 the power of the amp. The other thing was how were they wired. Its would be about a 1.3ohm load assuming a 4 ohm speaker. Which for a Kenwood amp is likely to low. Now that is very technical basically that amp is not built to handle that load. Now if you wired the subs where the positive and negative teminals are hooked up oppisate then the subs could be canceling each other out. There are so many variables that can effect out put. I would need a list of all components in the system plus how they are all wired.
David