03-14-2009, 01:11 PM
hardk0re,Mar 13 2009, 10:05 PM Wrote:drunkinmonkey,Mar 13 2009, 11:02 PM Wrote:SL8RZZX3,Mar 13 2009, 09:52 PM Wrote:It IS engaging the first lock and NOT the second lock right?
[right][snapback]282670[/snapback][/right]
CORRECT
[right][snapback]282673[/snapback][/right]
I had the same issue, had to grind down the bottom of the U part where the hood latch slides down. Same symptom, fit Gords car but not mine.... after I used a chisel (since its sharp and flat) to just grind out the U a little deeper it fit fine.
[right][snapback]282676[/snapback][/right]
its really hard to picture what you mean sorry
2000 dark violet pearl zx3: eagle rods, je pistons, fidanza cam gears, arp studs, ford racing highlift valve springs, svt front/rear disc conversion, prothane total kit, fc 65mm throttle body Tial gt3071r, tial mvs wastegate, tial Q bov, top speed "street" manifold,down pipe and dump tube, greddy boost controller, siemens deka #61 injectorz, stage 4 bully clutch way to much more to list
Instagram @o_so_slo
Instagram @o_so_slo