Hi, Guest
12-21-2011, 05:52 AM
yeah quarter panels are made of fiberglass and it is whole rear quarter panels.
but i didnt want to remove glass and drill out all spot weld to seperate..
so instead, i used 1" painters tape to cut along the edge and did same thing to fiberglass quarer panels.
i will put some plates behind to support fiberglass panels, i m testing using black silicone to see if it is sturdy..if it is too flexible, then i might have to use epoxy or plastic weld.
but i didnt want to remove glass and drill out all spot weld to seperate..
so instead, i used 1" painters tape to cut along the edge and did same thing to fiberglass quarer panels.
i will put some plates behind to support fiberglass panels, i m testing using black silicone to see if it is sturdy..if it is too flexible, then i might have to use epoxy or plastic weld.
BLACKBOX(DASHCAM) | LED | HID | REMOTE STARTER + SECURITY | 12 VOLT ACCESSORIES | CAR ENTERTAINMENT | PERFORMANCE UPGRADE | MAINTENANCE REPAIR
![[Image: banner_468x60_zps1c433cb9.gif]](http://img.photobucket.com/albums/v452/konafocuswrc/motormaniac/banner_468x60_zps1c433cb9.gif)
info@motormaniac.ca | 905.508.3737
If you are calling after hours, please leave a pm or detailed voice mail and we will get back to you as soon as possible.
![[Image: banner_468x60_zps1c433cb9.gif]](http://smg.photobucket.com/user/konafocuswrc/media/motormaniac/banner_468x60_zps1c433cb9.gif.html)
info@motormaniac.ca | 905.508.3737
If you are calling after hours, please leave a pm or detailed voice mail and we will get back to you as soon as possible.