Hi, Guest
03-20-2005, 08:24 AM
(This post was last modified: 03-20-2005, 08:28 AM by microbunny.)
yo..
I just actually finished the full install on my 2005 ZX5....took me 2 days, (took my time) and here is what I say,,
Run the 4 gauge power wire under the trim on the left side of your car....battery..to fuse block...through the firewall..under all the left side trim...and route under your rear seat....
run speaker wires and 3 sets of rcas on the right side,,,from the back of the deck...behind the glove box...behing kickpanel...under all the trim...routed under rear seat and into trunk...
..if you want detailed explaination on removing everything just let me know...everything is ultra fresh in my head....
whatever you do..dont run the power wire underneath,,,,go through the firewall,,,there is a little plastic cover piece above the brake & clutch behind some carpet...drill through that...and run into engine bay from there....
also make sure your power wire is on one side...and everything else is on the other side... like mentioned above^^
I just actually finished the full install on my 2005 ZX5....took me 2 days, (took my time) and here is what I say,,
Run the 4 gauge power wire under the trim on the left side of your car....battery..to fuse block...through the firewall..under all the left side trim...and route under your rear seat....
run speaker wires and 3 sets of rcas on the right side,,,from the back of the deck...behind the glove box...behing kickpanel...under all the trim...routed under rear seat and into trunk...
..if you want detailed explaination on removing everything just let me know...everything is ultra fresh in my head....
whatever you do..dont run the power wire underneath,,,,go through the firewall,,,there is a little plastic cover piece above the brake & clutch behind some carpet...drill through that...and run into engine bay from there....
also make sure your power wire is on one side...and everything else is on the other side... like mentioned above^^