[dBlast]

Jays2000ZX3,Jun 17 2005, 12:46 AM Wrote:It's illegal because you have pressure venting from the motor out into the atmosphere, this air is not clean, has bad stuff in it therefore causing a emmissions violation.

Not to mention that you SHOULD have it hooked up because the intake usually vaccumes the air out of the valve cover and back into the motor.

Bottom line, if a MTO cop pulls you over and you have a breather filter, $300 fine.
[right][snapback]114915[/snapback][/right]

In stock form where is this tube from the motor connected? When I had the short ram intake it was connected to the intake between the MAF and the TB. (I did not install it so I don't know the original location)



Now that I have a JRSC which comes with a flex tube between the MAF and TB, there was no place to connect this. I attached the cone filter from the short ram on the end of the MAF housing. The guys the installed the JRSC hooked up a breather filter.



If it normally ran into the airbox then I would be looking at getting an SVT airbox and snorkel to replace the cone at the end of the MAF. If it normally ran into the tube between the MAF and the TB then I would have to get a custom connection made because the JRSC TB location is different than the stock location and it uses a flex tube with no way of connecting this tube.