[schade]

ya Bake ... according to this Urethane Parts Paint Prep sheet i got from wings west with the kit, it says:

"If a bake booth is available, the first step is to bake all the urethane parts for 2 hours at 80 degrees. If you do not have a bake booth, placing the parts in the sun, or use of a hair dryer will owrk fine. This will allow the part to sweat out oils in the urethane and any trapped gases."

then after this your supposed to clean it with soap and water then apply some plastic adhesion primer, then begin with regular primer and base coat

To me, it sounds like all wings west does is pop the parts from the mold and toss them in a box and ship to your door