10-15-2009, 08:35 AM
ZX3_2NV,Oct 14 2009, 12:16 PM Wrote:drunkinmonkey,Oct 13 2009, 06:50 PM Wrote:does anyone here no where to get motocraft spark plugs in canada???
im not paying under $12 for the plugs and $35 shipping to get over to canada from CFMÃÂ its quite the rip off
[right][snapback]295931[/snapback][/right]
I have a few sets 4 or 5 I think that I've never used I'll let them go for $15 a set. The CFM ones are the best for boost I never used anything else.
As for building a motor
drunkinmonkey, Wrote:so far i have a new valve cover coming and fidanza cam gears on the way
also got gates racing blue timming belt and serpentine belt coming as well
should i wory about upgrading the pistons and valves???
turbo cams??[right][snapback]295931[/snapback][/right]
That shows that you have not done your research But I will keep my comments positive. Cam gears and a Blue Timming belt are not going to add horsepower to your build. Are you asking if you should upgrade the pistons :unsure: because that should be at the top of your list aswell as rods. As for the head just get the stock one ported. Something that you should conisder is a aftermarket Crank to go with the pistons and rods. I went with the Ford Racing One and it wasn't cheap.
Something thats are usally forgotten that I would 100% suggest Are Upgrading the coils and wires, Proper Piston rings, ARP stud kit, SVT fuel Pump and a throttle body. As for the turbo kit go with a bar and plate intercooler not a tube and fin!!!
One thing no one has mentioned as of yet is tunning which way do you want to go with tuning software. I went with SCT which was great but for around 300 whp It needs a full stand alone. So good luck with your build if you need suggestions im more than willing to help since Ive been threw all of this before.
[right][snapback]295992[/snapback][/right]
pistons and rods are top priority on my list acually i have already priced rods out at my work and will be ordering soon...spark plugs i got today the exact ones your sellin gand got 8 plugs for $20 from ford (thats 2 sets)...pistons i already have looked as well ported has also already been taken care of... as for wires i already got taylor thundervolts and as for ARP hardware i got that aswell
2000 dark violet pearl zx3: eagle rods, je pistons, fidanza cam gears, arp studs, ford racing highlift valve springs, svt front/rear disc conversion, prothane total kit, fc 65mm throttle body Tial gt3071r, tial mvs wastegate, tial Q bov, top speed "street" manifold,down pipe and dump tube, greddy boost controller, siemens deka #61 injectorz, stage 4 bully clutch way to much more to list
Instagram @o_so_slo
Instagram @o_so_slo