[ANTHONYD]

Any way you can give me a hand making these? I want one for each amp, and I think those would solve my mount + cargo problem.

I figure it would be pretty easy seeing you have a table saw, router and knowledge....

Let me know. I'll buy the wood and beer. (Beer for AFTER we use the table saw.)

[microbunny]

ohh...I see..

I'm no good to you anymore huh?!@?

bastard! :angry:

[nass]

just get a sheet of MDF ( or anything else for that matter ) a jigsaw. Measure the size of the amps cut out hole. Measure seats cut wood to match. Screw into seats.


add plexi-glass for bling and neon for rice. To get the bevelled look I'd sand the edges.

[meford4u]

Help yep.

Whenever you want to sit down and hash out a plan, I'll be available.

I am just wondering how to reduce the weight and bulk up the wood to cover the amp. That's a good 2 and a quarter inches thick (I measured Aaron's)

Do you care how heavy they are?


They look like the perfect idea though.

You have to remember though that it would only work for the new amp and not the amp driving the sub as it is too large and doesn't fit on your smaller seat.

[ANTHONYD]

The old amp (sub) is going to stay where it is. I'm thinking of doing the surround for the new amp only.
This way I can remount the distribution block next to the amp. ***ka-bling***

[microbunny]

ANTHONYD,Jan 2 2006, 06:11 PM Wrote:The old amp (sub) is going to stay where it is. I'm thinking of doing the surround for the new amp only.
This way I can remount the distribution block next to the amp. ***ka-bling***
[right][snapback]162885[/snapback][/right]

Did you get the extra wire yet to hook up your sub

[ANTHONYD]

microbunny,Jan 2 2006, 08:49 PM Wrote:

ANTHONYD,Jan 2 2006, 06:11 PM Wrote:The old amp (sub) is going to stay where it is. I'm thinking of doing the surround for the new amp only.
This way I can remount the distribution block next to the amp. ***ka-bling***
[right][snapback]162885[/snapback][/right]

Did you get the extra wire yet to hook up your sub
[right][snapback]162896[/snapback][/right]

It's being done tomorrow.

I'm also having a proper face plate ordered / installed as well.

[meford4u]

ANTHONYD,Jan 2 2006, 11:48 PM Wrote:

microbunny,Jan 2 2006, 08:49 PM Wrote:

ANTHONYD,Jan 2 2006, 06:11 PM Wrote:The old amp (sub) is going to stay where it is. I'm thinking of doing the surround for the new amp only.
This way I can remount the distribution block next to the amp. ***ka-bling***
[right][snapback]162885[/snapback][/right]

Did you get the extra wire yet to hook up your sub
[right][snapback]162896[/snapback][/right]

It's being done tomorrow.

I'm also having a proper face plate ordered / installed as well.
[right][snapback]162973[/snapback][/right]

Stop by if you get a minute after it's all done so I can "test" it out :lol: