[meister@steeda.ca]

SVTmonkey,Dec 13 2004, 07:59 PM Wrote:This car did seem to baseline pretty low, especially on the torque.

I do understand that you guys just started and haven't really had much time on it, I'm waiting patiently, I haven't lost hope ;).

I'll be interested in the Short Ram version.  Will you guys add the mods one at a time, or just have them all at once?

Edit: Also, why is that power curve peaking so late...doesnt the tq peak at 5.5 on SVT?
[right][snapback]74315[/snapback][/right]

Yes it did baseline a tad lower then most others "seen online". This is why you can't always compare dyno sheet's and numbers, cause in fact you comparing apples to oranges. A few mods might be different (UDP and Short intake is quite a bit), baseline numbers, etc...this is why you MUST look at the gains from mods, tuning, etc.

I know the next time we get on the dyno, we can pick up a few more ponies up top and get a bit more agressive...this is a VERY conservative tune.

We will put the pulleys on, and dyno the car with and without the tune to show gains from just pulleys and pulleys with the tune. We will then put on the intake and dyno with and without a tune again to show gains that way. We might have to do it in 2 sessions, but we will post everything asap. When I do my testing I ensure conditions are as close to the same for each pull (temp readings, sensor readings, etc)

The gains this stock SVT Focus saw are right in line with where they should be and no reason can be see as to why someone would not choose to run our program.

If you have any more questions, please let me know