Hi, Guest
01-24-2013, 03:59 AM
Just took a look at the CFM tubulars, and two points that I like about them..
1) They're heat treated, so less likely to suffer failure near welds
2) more consistent load distribution across the torsional axis (longer, spaced out tubes)
My one major concern:
1) Rod ends - if you go with these, better spring for the boot.
1) They're heat treated, so less likely to suffer failure near welds
2) more consistent load distribution across the torsional axis (longer, spaced out tubes)
My one major concern:
1) Rod ends - if you go with these, better spring for the boot.
Contribute to focuscanada.net's future!
Donations of $20 and over get a custom title!