[Scorcher000]

I had some time while I was taking it easy this week at work.

I sat the tail lights in place. I still have to run some wiring from the front signal markers to turn the LED tail lights into LED Euro lights.


I laid the watermeth tank and the battery in place in the spare tire wheel well.


I hooked up the battery terminals posts and installed my mini oil catch can. I have yet to run the hoses to it yet.


Ran the power lines from the alternator to the starter and then to the positive terminal post.


I installed my intercooler piping finally. But just as a pre fitting. I have to have the fabricator come out and look at it to see where to install the pipe hangers and bungs for the BOV, Watermeth and IAT.




I spliced into my fuel line and installed my Prosport Fuel Pressure sensor. Gauge will be installed later.


I installed my Prosport Exhaust Gas Temperature sender and the gauge will be installed later on with the fuel pressure gauge too.
I had to drill into the turbo manifold. Then I tapped it and treaded the sender into the hole for a tight seal.



Also I installed my special item. A reproduction Mopar Road Runner Horn. I love the sound of it and it is nice and loud too!!!



I also installed my new stereo and just waiting on some interior pieces to bolt it into place. I am halfway on installing all of my LED conversion lights. and I ordered a Diablo Mafia MAF adapter. I still have to order the SCT software. I am just pricing it out from a couple sources. Sean gave me his price and it seems to be the one I may choose yet!
I tried to turn the engine over just it just creates a bunch of clicking noise and then it just does nothing.
I still have to roll the rear end and install the Eibach Sportline rear coil springs and take out the Ksports because the Ksports are way to small to work with my custom lower control arms.