[paulicat]

Ok bringing it back from the dead.
Backyard took way longer than expected.
However, I'm getting back on track for the car.
The suspension is all completed, Steeda put on the front sway bar, but I've got poly bushing creaking which I want them to look at when it goes in for a tune. The creaking is brutal over any bump where both wheels get loaded/unloaded at the same time. I can't imagine the Saleen Foci came like this...
Anyways, I'm finally bringing in the car to have them check the front grumbling/rumbling sound. I'm fairly certain its the wheel bearings and I've got extended warranty till July 21st...its getting close to the cutoff.
After this is done, I'm picking up whatever Steeda suggests to take care of the MAF (MAFia, SVT MAF or 3 inch MAF tube) and an Xcal3 with a startup tune. I'm hoping for an install on the weekend of the 26, 27th.
I've catalogued all my nuts/bolts/studs for the Procharger and everything is in good order. Just need to pick up some quality silicone couplers for the charge piping.
Off hand does anyone know where I can get some charge piping beaded??
Some of the piping doesn't have beads on it and I've heard of too many stories of peoples couplers popping off under boost without beads.
I'll do a better job of taking snaps of the Procharger install than I did with the suspension (I know, I took none, sorry). The wife's going to be the designated photographer. :D
I've read you're supposed to change the PCV to a specific model when going with boost. Anyone know the part# off hand??
Here she is all cleaned up with the 17's on:

Just noticed, you can see my wifes silver se in the reflection...she no longer has it, we got an Edge for the "family".
Cheers!