Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Cleaning & Re-oiling A K&n Filter
#1
Almost time for the car to get it's winter tune up. Do I need to clean and re-oil my filter? I've had it on the car for about 25,000 km, and the box says it's good for 50,000 miles, but is that really true? If I do need to change it, what's involved? Do I need to buy a re-oiling kit?
2000 Black ZX3
Blacked Out Head & Tail lights - APC Clear Turn Signals - 20% Tint All Round - K&N Filter - Cheap ass fogs that are brighter than my headlights - Clarion DXZ745MP - Jensen XA 4100 amp on Mobile Authority 200w 6x8's - Jensen 340w amp on a 12" Rockford Sub, custom enclosure - KYB GR2 Dampers - SHM Springs @ 1.5" - Brembo Cross Drilled Rotors w/ CVR Ceramic Pads - Silver Gauge Bezel - Focus Central 2-Piece Under Drive Pullies - 17 x 7 Rims by Fast Wheels mounted on 215/40/17's - Wings West W-Typ front lip - Coming Soon: Paint, Component Speakers (Spring 06)
Reply
#2
Just buy a new filter. $30

Many ppl over oil there filter and in fact actually burn there MAF out.
Reply
#3
You won't burn your MAF out if you let the filter properly dry for 24 hours before re-installing it.
Buy the kit. I think I do the truck every 10k and Aaron does the car every winter. If you have a paper back up you can use for 24 hours then that is a perfect scenario.
TEAM PITA Don't settle for a wannabe, only accept the real deal.

One day I will rule the world. For now, I have to settle for this place.
Reply
#4
You need to buy the cleaner and oiler. I find the spray bottle cleaner works better than the can. Make sure you lay the filter (panel or cone) on newspaper because it can get messy. Read the instructions on the bottle. I rinse the cleaner out with the water from the laundry sink taps.
I've been using K&N for about 20 years and never had a problem cleaning them. Just don't over oil it and you're okay.
I've actually been told by racers that the filter works better when it's dirty B)
I clean mine once a year at the most.
Old enough to know me limit, yet young enough to exceed it.
Reply
#5
CanadaSVT,Oct 13 2005, 06:08 AM Wrote:You need to buy the cleaner and oiler.  I find the spray bottle cleaner works better than the can.  Make sure you lay the filter (panel or cone) on newspaper because it can get messy.  Read the instructions on the bottle.  I rinse the cleaner out with the water from the laundry sink taps.
I've been using K&N for about 20 years and never had a problem cleaning them.  Just don't over oil it and you're okay.
I've actually been told by racers that the filter works better when it's dirty B)
I clean mine once a year at the most.
[right][snapback]148623[/snapback][/right]

Ditto, I had them on my Kawasaki forever and the Focus for 5 years. Once a year at best and I plop in thepaper filter for a couple days while it dries.
2001 Focus ZTS 2004 WRX
"I'm just here for the camping"
http://www.facebook.com/profile.php?id=687620231
TEAM P.I.T.A. FTW!
Reply
#6
I'd say just buy a second one so you always got one ready to roll and don't need to turn it into a big ordeal just to swap a filter.
Reply
#7
I second Kevin's idea. I'm considering doing just that in January, when my current cone turns one year old.
Daily driver 1: 2007 Jeep Wrangler Unlimited Sport "S"

33" BFG Mud-Terrain KM2s, lots of Rough Country gear - bumper, 2.5" lift, swaybar disconnects, Superwinch 10,000lb winch, Detroit Locker in rear D44 axle, custom exhaust, K+N filtercharger, Superchips-tuned.

Daily driver 2: 2006 Subaru Legacy GT

COBB Stage 1+ package - AccessPort tuner, COBB intake and airbox. Stage 2 coming shortly - COBB 3" AT stainless DP and race cat, custom 3" Magnaflow-based exhaust and Stage 2 COBB tune.
Reply
#8
hardk0re,Oct 13 2005, 08:09 AM Wrote:I'd say just buy a second one so you always got one ready to roll and don't need to turn it into a big ordeal just to swap a filter.
[right][snapback]148627[/snapback][/right]

I'm going to do that when they go back on sale again at Canadian Tire. Sometimes, it takes a while for the filter to dry after you wash out the crap. I've haven't had the time to just let things sit while I need to be across the cities in 30 minutes. It's out of convenience really.

But if you want to save the money, just make sure you have a good few hours for the filter to dry after washing, as well as some good few minutes to let the oil soak in.

PS> I usually clean mine twice a year - spring and fall. I might clean it before hitting the On Track, but that's about it. Unless you are in a really dusty and/or rural environment, there shouldn't be a need to clean it more than that.

Note though I wouldn't just leave it in there and forget it. Take it out periodically and inspect it. Lots of times, I find some of those dandelion spores or chunks of leaves get inhaled. If it gets dirty, then clean it.

When you do inspect it, look at the piece of breather foam that is at the bottom. I think it's just a few bucks, but I've found that if you didn't let the oil dry completely, it can muck up this foam.
Richard | Focused 24-7
2002 ZTS | Sangria Red | +400,000 km - most of it avoiding potholes 100km/h at a time

OFOC - Ontario Focus Owners Club | SVTOA-Toronto | Redline Rendezvous @ Mosport International Raceway
Reply


Possibly Related Threads...
Thread Author Replies Views Last Post
  Cleaning The Filter On A Sri Canadian ST 2 1,203 10-29-2007, 05:55 AM
Last Post: Oscar The Grouch
  Re-oiling A Filter nass 8 2,227 08-13-2005, 08:56 PM
Last Post: ANTHONYD

Forum Jump:


Users browsing this thread: 1 Guest(s)