Hi, Guest
07-17-2011, 10:00 AM
You might not want to cover the whole taillight either. I got a couple of inexpensive spares to play with. Wrapped them in a non-slip for a carpet. (I borrowed this idea from a computer modding site showing how to air-brushed a carbon-fiber look.) Then I sprayed through the holes in the foam, pulled the foam off, then sprayed the edges darker. The middle is just lightly covered. You could also tape off an area with a pattern, etc. Get creative!
![[Image: taillight2.jpg]](http://img.photobucket.com/albums/v282/moon111/taillight2.jpg)
(I chose this picture because it shows the pattern better, but in reality, one can barely make out any red)
With just a light covering in the middle part, I think the brake lights themselves are very visible. I tried a set of LED's from CTC, and they're garbage so I went back to regular bulbs that do a better job.
![[Image: Taillight.jpg]](http://img.photobucket.com/albums/v282/moon111/Taillight.jpg)
After looking at this, think I'll wash her tonight!
(I chose this picture because it shows the pattern better, but in reality, one can barely make out any red)
With just a light covering in the middle part, I think the brake lights themselves are very visible. I tried a set of LED's from CTC, and they're garbage so I went back to regular bulbs that do a better job.
After looking at this, think I'll wash her tonight!