Hi, Guest
08-11-2011, 12:45 PM
I had to swap the transmission out of my 2002 and picked up a 2000 with low miles on it. but to make the 2000 i had to swap the shift linkage from the 2002 onto it so that the cables would work.
i've run into a problem now though and do not have any solutions left. the counter weight on the linkage is hitting the nut on the top transmission mount stud when i try to put it in 1st and 3rd gear.
i cannot figure out a way to get the clearance over then nut and everything seems to be in the correct position.
has anybody run into this problem before?
i've run into a problem now though and do not have any solutions left. the counter weight on the linkage is hitting the nut on the top transmission mount stud when i try to put it in 1st and 3rd gear.
i cannot figure out a way to get the clearance over then nut and everything seems to be in the correct position.
has anybody run into this problem before?
'05 Grand Cherokee LTD Hemi
'02 black ZX5 ****currently on jack stands my parents garage missing a transmission****
--FC/OBX 4-2-1 Race Header--FS Flex--MBRP catback exhaust--AEM CAI--Brembo Brakes with Hawk HPS pads--Toucan(ractive) 9mm Plug wires--FC Plug wire cover--Polished aluminum Ractive Strut Bar
Not installed: FK 60/40 Springs
'02 black ZX5 ****currently on jack stands my parents garage missing a transmission****
--FC/OBX 4-2-1 Race Header--FS Flex--MBRP catback exhaust--AEM CAI--Brembo Brakes with Hawk HPS pads--Toucan(ractive) 9mm Plug wires--FC Plug wire cover--Polished aluminum Ractive Strut Bar
Not installed: FK 60/40 Springs