Hi, Guest
04-19-2005, 10:13 PM
Jack the car up and look at the rear of the engine by the oil filter. You will see right beside there is a sensor in the block, thats the oil temp sensor. Then about the same position vertically on the engine right by the starter (6 inches away). You will see a plug(well you may or may not see it depending on your angle it is a little lower than the other port where the oil temp sensor is in.
I found I had to use a T35 Torx bit to get a good grip on the plug, the T30 was too loose and it felt like I was going to strip the plug if I put too much force on it. And these damn things are in there good, the whole thing is awkward to get a ratchet on, but honestly once you get the plug out its a million times easier the rest of the way....
I found I had to use a T35 Torx bit to get a good grip on the plug, the T30 was too loose and it felt like I was going to strip the plug if I put too much force on it. And these damn things are in there good, the whole thing is awkward to get a ratchet on, but honestly once you get the plug out its a million times easier the rest of the way....