Hi, Guest
05-07-2005, 05:02 AM
haha, sorry i glanced over the "auto" in your sig which would explain why the power is so low.
the numbers still seem a bit low but after looking at the dyno graph it doesn't look the cams were installed incorrectly. and if McNews did the dyno, i'm sure they would have noticed if the cams were not installed propperly. Focaltech is a bit of a wanker but he does know what he is doing when it comes to cars.
check out this thread of another modified auto focus:
http://forums.clubfocus.net/viewtopic.php?t=27518
if that was on a manual focus those numbers would look more like 150+fwhp and 140+lb/ft, probably closer to 160fwhp and 147lb/ft so you can see the loss in power from the auto.
but back to your original question, don't worry about getting a reburn if you are planning on adding a TB or other little basic mods, it should not make a big enough difference to require it. finish off ALL of the basic mods then get it reburnt and be done with it! :D
the numbers still seem a bit low but after looking at the dyno graph it doesn't look the cams were installed incorrectly. and if McNews did the dyno, i'm sure they would have noticed if the cams were not installed propperly. Focaltech is a bit of a wanker but he does know what he is doing when it comes to cars.
check out this thread of another modified auto focus:
http://forums.clubfocus.net/viewtopic.php?t=27518
if that was on a manual focus those numbers would look more like 150+fwhp and 140+lb/ft, probably closer to 160fwhp and 147lb/ft so you can see the loss in power from the auto.
but back to your original question, don't worry about getting a reburn if you are planning on adding a TB or other little basic mods, it should not make a big enough difference to require it. finish off ALL of the basic mods then get it reburnt and be done with it! :D