Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bore-out Stock Tb
#11
I bought a set of bits from CrappyTire (15 bucks) along with some epoxy putty and fine grit sandpaper. If you take off your intake you will see that the inside of the TB dips in , then out again towards the back. All I did was take off the fins, and made the circle perfectly round...big difference felt/heard right away. What I was most worried about was the top of my manifold, and debris falling in while taking the TB off/on, just be very careful.
2002 Infra-red ZTS
Reply


Messages In This Thread
Bore-out Stock Tb - residentdud - 03-27-2006, 03:35 AM
Bore-out Stock Tb - euro_zx5 - 03-27-2006, 08:45 AM
Bore-out Stock Tb - residentdud - 03-27-2006, 09:38 AM
Bore-out Stock Tb - tdot-zx3 - 03-28-2006, 08:28 AM
Bore-out Stock Tb - Flofocus - 03-28-2006, 08:39 AM
Bore-out Stock Tb - euro_zx5 - 03-28-2006, 08:55 AM
Bore-out Stock Tb - residentdud - 03-28-2006, 09:39 AM
Bore-out Stock Tb - laidman - 03-28-2006, 11:34 AM
Bore-out Stock Tb - 01-yellow-ZX3 - 03-28-2006, 02:42 PM
Bore-out Stock Tb - Focus man. Focus. - 03-28-2006, 10:35 PM
Bore-out Stock Tb - residentdud - 03-29-2006, 07:44 AM
Bore-out Stock Tb - residentdud - 03-29-2006, 07:48 AM
Bore-out Stock Tb - residentdud - 03-29-2006, 07:56 AM
Bore-out Stock Tb - 02ztsian - 03-30-2006, 01:32 AM
Bore-out Stock Tb - NikiterZTS - 07-10-2006, 11:29 AM
Bore-out Stock Tb - habmann - 07-10-2006, 11:45 AM
Bore-out Stock Tb - Oscar The Grouch - 07-10-2006, 10:02 PM
Bore-out Stock Tb - NikiterZTS - 07-15-2006, 03:14 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)