05-20-2013, 12:31 AM
(05-19-2013, 11:57 AM)konafocuswrc Wrote: actually whoever assembled that taillights did not use proper resistors to work with cars.
they need to think that voltage goes all the way up to 15.2v and they really need to use zener diodes to regulate voltage..
this is a common problem when people use leds that are constantly ON while driving.
They are always off, unless I turn my lights on, when I signal every LED goes bright same goes for braking, I never used resistors cause it worked fine for a couple months didn't think it be a problem, the lights in the car where fine none stayed on but my blinker was faster, due to not having a resistor. So that was my mistake, I should of put them in.