Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Won't run after new clutch + flywheel install
#1
So we just put a new aluminum flywheel and stage 3 clutch in my svt . The car ran when we brought it into the garage . Now after the install the car starts but is acting like it's running on 1 cylinder . We checked out coil , wires , pigtail that goes to the coil and they are all good . Even swapped out a new coil pigtail and a combo of different wires and coils , still same thing . I'm gonna start scavenging to see if I missed any pigtails but anywhere I should look next ? Crank position sensor ?
2002 SVT Focus
Procharger @ 10psi , Clutch Masters Stage 3 Clutch,Stainless Borla Exhaust, Ebc dimpled + slotted rotors and brakes ,Russel Stainless brake lines , Koni adjustable shocks ,Eibach Sportline Springs , CFM short throw shifter , Euro Grill , CFM 65mm tb , Mach Headlights , MSD Coil ,SCT Dyno tune @ steeda , Volant Intake .  
-2003 SVT Wagon - Euro Conversion , currently retired
Svt side skirts , st170 front bumper , mach headlights , spax rear adj shocks , focus sport rear springs , volant CAI , Roof rack delete , Street edition Spoiler , MBRP exhaust , Eibach front swaybar , shorty shifter and lots more to come!                             .
2011 SES - daily driver will be modded soon .                                                                                                                                                        
Reply


Messages In This Thread
Won't run after new clutch + flywheel install - 2000zx3sct - 06-15-2015, 03:30 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)