FocusCanada Forums Canadian Focus Community Focus Talk Won't run after new clutch + flywheel install

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Won't run after new clutch + flywheel install
2000zx3sct Offline
HoCuSPoCuSFoCuS
****
Posts: 828
Threads: 61
Joined: May 2012
Reputation: 2
#37
07-01-2015, 12:58 PM (This post was last modified: 07-01-2015, 01:07 PM by 2000zx3sct.)
Well we found the problem , linkage cables have to be replaced . Thankfully it's not the transmission . This svt motor and trans will be a good donor for my wagon. The wagon motor has a good 270,000 Kms on it so this one will be a good replacement .


Attached Files Thumbnail(s)
   
2002 SVT Focus
Procharger @ 10psi , Clutch Masters Stage 3 Clutch,Stainless Borla Exhaust, Ebc dimpled + slotted rotors and brakes ,Russel Stainless brake lines , Koni adjustable shocks ,Eibach Sportline Springs , CFM short throw shifter , Euro Grill , CFM 65mm tb , Mach Headlights , MSD Coil ,SCT Dyno tune @ steeda , Volant Intake .  
-2003 SVT Wagon - Euro Conversion , currently retired
Svt side skirts , st170 front bumper , mach headlights , spax rear adj shocks , focus sport rear springs , volant CAI , Roof rack delete , Street edition Spoiler , MBRP exhaust , Eibach front swaybar , shorty shifter and lots more to come!                             .
2011 SES - daily driver will be modded soon .                                                                                                                                                        
Find
Reply


Messages In This Thread
RE: Won't run after new clutch + flywheel install - 2000zx3sct - 07-01-2015, 12:58 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)